Order Tracking
|
Log In
|
Cart Contents
|
Checkout
Health & Beauty
Health Supplements
Special Supplements
Musics & e-books
Best Sellers
Beauty and Fitness
|
Sauna and SPA
|
Massager
|
Infrared Energy
|
Acupuncture
|
ElectroMagnetism
|
Medical and Health
Categories
Beauty and Fitness
Health Supplements
Music & e-books
Special Supplements
Sauna and SPA
Massager
Infrared Energy
Acupuncture
Acupunctoscope
Acupuncture Model
Acupuncture Needle
Acupuncture Supply
Diagnostic Device
Electro Acupuncture
Laser Apparatus
ElectroMagnetism
Medical and Health
Book and Medicine
Cards We Accept
Coupon Zone
01.
test coupon
Home
»
Acupuncture
»
Electro Acupuncture
»
pd-3981
Pointer Excel II
[pd-3981]
List Price:
$200.00 USD
Our Price: $182.00 USD
You Save: 9% or $18.00 USD
US & Canada Shipping cost: $21.50 USD
Instructions For Use
:
Insert the 9 volt battery onto the battery clips, the positive and negative poles of the battery should always be matched correctly with the respective battery clips. A 9 volt Duracell or other alkaline battery is recommended for the best performance.
Two different probes are provided for different applications. The larger probe may be used for larger areas or body points while the small probe may be used for ear points or other smaller body points.
For self-use, touch the grounding metal plate(s) on the front side or underneath the unit and then search for the point.
Press each point slightly; the probe uses a spring mechanism so that a constant pressure may be maintained during location.
The
trigger point is located when a continuous sound is heard from the buzzer and at the same time the LED light located in front of the Loc/Stim button is flashing continuously
.
If stimulation is required on this point, simply adjust the intensity knob INT to an acceptable level and press the loc/Stim button. When this button is released, the unit is immediately returned to the point detection mode. Pressing the Loc/Stim button again will produce output stimulation. The intensity is controlled with the intensity knob labeled INT. Turn the switch clockwise to increase the output intensity. Micro current intensity is emitted when the switch is in the blue zone. When treating with micro current intensity, there will be very little or no feeling of stimulation achieved, even if the probe is located at the trigger or acupuncture points.
It is recommended to begin treatment with a low intensity setting, thereafter turning the INT control until a comfortable intensity is reached.
In order to treat patients, the grounding pole must be attached with the plug jack to the bottom of the unit. The patient must hold the grounding pole to complete the electrical circuit which then activates the detection and stimulation functions.
This device is equipped with a Polarity switch. If a positive (+ for tonification) or negative (- for sedation) pulse stimulation is required, simply set the switch to + or -position.
The Digital Display chamber is located on the rear top side of the unit, it features a digital display to show the frequency (from 1 to 16Hz) of stimulation during operation, and numerical display (maximum around 500 when sensitivity adjustment to highest range) to show the sensitivity of detection during the location of acupuncture points.
Turn off the unit after use. Remove the battery from the unit when the device will not be used for a long period of time.
Battery information:
Your stimulator requires 1 9V battery, use PP3, 6F22 or its equivalent type of battery (Alkaline battery is recommended). The battery is replaced by opening the battery door on the bottom side of the Unit. Slide the battery door off, remove the old battery and insert the new battery. Insert the battery correctly with the polarity according to the diagram shown in the battery compartment label. Make sure the directions of positive and negative poles of battery inserted is correct and be sure you are using a fresh battery. Close the battery door. Battery life is 4 to 20 treatment hours depending on how high the current is set and how long each treatment session is. Many short treatment sessions give longer battery life than fewer longer sessions. To avoid battery leakage, remove the battery if the unit will not be used for an extended period of time.
Length Of Treatment:
The length of treatment or stimulation time depends on the point or area to be treated as well as other factors. Generally, treatment times may vary from 3,5,10, or 20 seconds, longer times may also be necessary in some cases. The best treatment times and intensities should be selected based on the practitioners experience and training.
[<<Prev]
1
2
3
4
[Next>>]
Current no reviews for this product
Write a new review >>
Advance Search
Advanced Search
Shopping Cart
0 items
Your Account
Your Email Address
Your Password
Best Sellers
01.
Pointer Excel II
02.
Acupressure Device JT-05
03.
Magic Needle (QZT-8)
04.
Electroacupuncture Device - Pointer Plus
05.
Electro-Acupuncture GB1002
Information
Ordering Info
About Us
Pricing Policy
Privacy
Return Policy
What is ISO13488
Shipping Info
FAQ
Herbal Safety Guidelines
INFRARED JADE MATTRESS CONTROL PANEL
HOW TO USE THE SILVER MATTRESS
Links
Contact Us
Site Map
Vendor
Thursday 29 July, 2010
SECURED - 100% WITH 128 BIT SSL
Copyright © 3DHealthStore
All Rightes Reserved
Copyright © 2006-2008
3DHealthStore
- All rights reserved | Conditions of use |
Privacy Policy
*** All prices in USD (U.S. dollars) ***