Order Tracking
|
Log In
|
Cart Contents
|
Checkout
Health & Beauty
Health Supplements
Special Supplements
Musics & e-books
Best Sellers
Beauty and Fitness
|
Sauna and SPA
|
Massager
|
Infrared Energy
|
Acupuncture
|
ElectroMagnetism
|
Medical and Health
Categories
Beauty and Fitness
Health Supplements
Music & e-books
Special Supplements
Sauna and SPA
Massager
Infrared Energy
Acupuncture
Acupunctoscope
Acupuncture Model
Acupuncture Needle
Acupuncture Supply
Diagnostic Device
Electro Acupuncture
Laser Apparatus
ElectroMagnetism
Medical and Health
Book and Medicine
Cards We Accept
Home
»
Acupuncture
»
Electro Acupuncture
»
pd-3981
Pointer Excel II
[pd-3981]
List Price:
$200.00 USD
Our Price: $182.00 USD
You Save: 9% or $18.00 USD
US & Canada Shipping cost: $21.50 USD
Unique Features:
The Digital Display chamber is located on the rear to side of the unit. The device features a digital display to show the working frequency (from 1 to 16 Hz) of stimulation during acupuncture treatment when pushing down the stimulation button, and a numerical display (maximum around 500 when sensitivity is adjust to the highest range) to show the sensitivity of detection during the location of acupuncture points. When used in Acupuncture or trigger point detection, the digital display will show the location of the acupuncture point in numerical form. During acupuncture location, the highest numerical value refers to the nearest site of acupuncture point. The green indication LED will remain lit when the acupuncture point is located.
The Polarity switch easily allows the output stimulation's polarity to be reversed from + (for tonification) to - (sedation) or vice-versa during acupuncture treatment. In doing this, the output intensity should be turned down first in order to avoid a sudden increase in intensity.
Acupuncture treatment through the probe may be used for the immediate treatment of the point or area right after its detection to the patient, by simply pushing down the stimulation/detection button on top of the unit. Immediate Point Location and Treatment: the button on the top of the unit may be pressed to activate the stimulation mode. A continuous electric pulse of 1 to 16 Hz (adjustable by turning the frequency dial) is emitted through the probe, the intensity may also be adjusted from 0 to 22mA. The intensity is controlled with the intensity knob labeled INT. Micro current intensity is emitted when the switch is in the blue zone. When treating with micro current intensity, there will be very little or no feeling of stimulation achieved even the probe is located at the trigger or acupuncture points.
Modern Spring Type Probe Tip
This new improved interchangeable spring type probe provides a more constant and comfortable acupressure to the area or points, thus providing better accuracy during point location searching. It is important to note that any part of the body may be induced to produce a point location signal depending on the amount of pressure used during location. Thus, it is important when locating the trigger points to use the
least amount
of pressure possible on the surface of the skin. Also, the movement of the probe when searching for the point should be smooth and graceful, always maintaining the same light uniform constant pressure until the correct point is found. The unique spring mechanism of the Pointer probe will add in correction for any slight variations in the applied pressure.
Interchangeable Probes
Two different probes (2mm and 4 mm diameter) are provided for different applications. The smaller probe is more suitable for ear points, and the wider probe is better for the body.
Sensitivity Adjustment
The point detection sensitivity is adjustable. The SEN knob is used to either increase (clockwise adjustment) or decrease (counter clockwise) sensitivity when used on different skin conditions (i.e. dry or moist skin). The level of sensitivity can be read from the Digital Display Chamber.
Hand Grounding Pole Accessory
The patient must hold the hand grounding pole in order to create a complete electrical circuit. This accessory is easily attached or removed from the unit. (Note: this unit may also be used without the grounding pole, however, in this case the practitioner must contact both the grounding plate(e) on the unit as well as hold the bare skin of the patient with his hand to complete the circuit.) The grounding pole is not necessary when using on oneself providing the grounding plate(s) on the unit is contacted.
Frequency adjustment dial, to adjust the frequency of stimulation from 1 to 16 Hz. The frequency selected can be read from the display chamber when pressing down the push type button on the front top of the unit.
Two ground plates, one located at the front left hand side, and the other one underneath the unit, to allow the user (or left handed user) to hold the unit and touch the ground plate(s) easily in closing the circuit for point detection or stimulation.
[<<Prev]
1
2
3
4
[Next>>]
review by: hyderabad on Oct 13, 2011
"I am verry happy for Acupresser and happy and happy and happy"
View more reviews >>
Write a new review >>
Current Reviews: 1
Advance Search
Advanced Search
Shopping Cart
0 items
Your Account
Your Email Address
Your Password
Best Sellers
01.
Pointer Excel II
02.
Acupressure Device JT-05
03.
Piezo Stimulator and Piezo Ear Pen
04.
Magic Needle (QZT-8)
05.
Electroacupuncture Device - Pointer Plus
Information
Ordering Info
About Us
Pricing Policy
Privacy
Return Policy
What is ISO13488
Shipping Info
FAQ
Herbal Safety Guidelines
INFRARED JADE MATTRESS CONTROL PANEL
HOW TO USE THE SILVER MATTRESS
Links
Contact Us
Site Map
Vendor
Tuesday 07 February, 2012
SECURED - 100% WITH 128 BIT SSL
Copyright © 3DHealthStore
All Rightes Reserved
Copyright © 2006-2008
3DHealthStore
- All rights reserved | Conditions of use |
Privacy Policy
*** All prices in USD (U.S. dollars) ***