3DHealthStore - Galvanic Stimulator PGS-123

Health & Beauty

Categories

Tens Electrode and Wire

TENS Unit

UltrasoundProfessional

Book and Medicine

Cards We Accept

Coupon Zone

01.	test coupon

Home » Medical and Health » Galvanic Unit » PGS-123

Galvanic Stimulator PGS-123
[PGS-123]

List Price: ~~$389.99 USD~~
Our Price: $279.00 USD
You Save: 28% or $110.99 USD
US & Canada Shipping cost: $14.45 USD

Instructions of Operation

This section explains how to operate the Pulse-Galvanic stimulator.
This single channel device is easy to understand.
Skin Preparation:
The treament site should be carefully examined and cleaned. An alcohol wipe is recommended.
Eletrode Preparation:

Clean the electrode application sites.
Apply gel in an even layer( about as thick as a match book cover ) to the bottom of the electrode. Avoide using excessive amount of gel.
The electrode attached with adhesive tape. Be sure that all sides are evenly taped and that the electrode is held firmly against the skin.
Remark: If you use the self-stick electrodes, then you can skip step 2 and step 3.
Insert the pin connector into electrode socket. For some electrode locations, it may be preferable to insert the pin connector before attaching the electrode to the skin.

The following procedure will ensure a safe and comfortable treatment.

Set all dials and switches to zero.
Attached active electrode directly over the treatment site.
Attached the dispersive pad proximal.
Set the pulse rate as directed by the clinician.
Select the desired polarity and function mode as diected by the clinician.
Turn the power on. LED will be on ( green color )
Slowly turn up the amplitude until you reach the amount of stimulation recommended by the clinician.
The duration of treatment should base on the recommendation of the clinician.
The amplitude is slowed reduced to zero, when the treatment has been completed.
Turn the power off.
Removing electrodes. Unplug the lead cable from the device. Also disconnect the lead cable from the electrode. Washing the conductive rubber electrode after every several uses, Dry before storing.

Troubleshooting

If your Plused-Galvanic stimulator device seems to work improperly, use the following guide to determine what may be wrong.

if the LED is off, check the batery condition, or replace battery with a new one.
Are electrodes in proper position?
Check lead wires.Make sure all cnnectors are firmly seated.
Replace cord set with another to check for broken wires.
Check the electrode condition. Following the electrode manufacture's instructions to check electrode.

Service

To obtain service, first calls your nearest dealer for assistance.
You may need to send your complete Pulsed-Galvanic stimulator system with a letter describing the problems.

Warranty

We warrant each Pulse-Galvanic stimulator system only ( excluding lead wires, electrodes, and battery) for 1 year from defects in materials and workmanship.This warranty registration card must be completed and returned to us within 30 days of purchase.
This warranty covers parts and labor for 1 year. Thereafter until the warranty expires, only the defective part will be repaired or replaced and the customer will have to pay for the labor.
This warranty does not cover abuse, accident, damage resulting from failure to follow operating instructions and alteration/disassembly other than by us.
The defective unit must be returned tu us postage prepaid and insured.
We shall not be liable for any direct or indirect consequential damages resulting from the use of unit.

[<<Prev] 1 2 3

Current no reviews for this product

Write a new review >>

Advance Search

Shopping Cart

0 items

Your Account

Your Email Address

Your Password

Information

Ordering Info
About Us
Pricing Policy
Privacy
Return Policy
What is ISO13488
Shipping Info
FAQ
Herbal Safety Guidelines
INFRARED JADE MATTRESS CONTROL PANEL
HOW TO USE THE SILVER MATTRESS
Links
Contact Us
Site Map
Vendor