3DHealthStore - Electroacupuncture Device

Health & Beauty

Categories

Cards We Accept

Home » Acupuncture » Electro Acupuncture »

Electroacupuncture Device - Pointer Plus

List Price: ~~$135.00 USD~~
Our Price: $122.00 USD
You Save: 9% or $13.00 USD
US & Canada Shipping cost: $16.50 USD

How to use The Pointer Plus Stimulator / Locator

Insert the 9 volt battery onto the battery clips, the positive and negative poles of the battery should always be matched correctly with the respective battery clips. A 9 volt Duracel or other alkaline battery is recommended for the best performance.
Select the correct probe for use with ear or body points
The larger probe may be used for larger areas or body points. The small probe may be used for ear points or other smaller body points
For self use, touch the grounding metal plate on the front side of the unit and then search for the point.
Press each point slightly, the probe uses a spring mechanism so that a constant pressure may be maintained during location. The respective trigger or acupuncture point is located when a continuous sound is heard from the buzzer and at the same time the LED light located in front of the APD / STI button is flashing continuously.
The sound emitted from the buzzer may be muffled or reduced by covering the holes of the metal grounding plate with your thumb.
If stimulation is required on this point, simply adjust the intensity knob â€œINTâ€ to an acceptable level and press the
APD /STI button. When this button is released, the unit is immediately returned to the point detection mode. Pressing
the APD / STI button again will produce output stimulation.
It is recommended to begin treatment with a low intensity setting, thereafter turning the â€œINTâ€ control until a comfortable intensity is reached.
In order to treat patients, the grounding pole must be attached with the plug jack to the bottom of the unit. The patient must hold the grounding pole to complete the electrical circuit which then activates both the detection and stimulation functions. The above procedures 6 to 13 are then followed.
Turn off the unit after use. Remove the battery from the unit when the device will not be used for a long period.

Electroacupuncture Device - Pointer Plus

Battery information:
Your Pointer Plus Stimulator requires 1 9V battery, use PP3, 6F22 or its equivalent type of battery (Alkaline battery is recommended). The battery is replaced by opening the battery door on the bottom side of the Unit. Slide the battery door off, remove the old battery and insert the new battery. Insert the battery correctly with the polarity according to the diagram shown in the battery compartment label. Make sure the directions of positive and negative poles of battery inserted is correct and be sure you are using a fresh battery. Close the battery door. Battery life is 4 to 20 treatment hours depending on how high the current is set and how long each treatment session is. Many short treatment sessions give longer battery life than fewer longer sessions. To avoid battery leakage, remove the battery if the unit will not be used for an extended period of time.

Length Of Treatment:
The length of treatment or stimulation time depends on the point or area to be treated as well as other factors. Generally, treatment times may vary from 3,5,10, or 20 seconds, longer times may also be necessary in some cases. The best treatment times and intensities should be selected based on the practitioners experience and training.

PRECAUTIONS: Do not use this device for any conditions listed below

* Patients with cardiac pacemakers * (unless physician approved) * Pregnant women (unless physician approved) * In the areas near or directly around the heart * Over recent scar tissue or new skin * Over abrasions or cuts

PERSONAL TESTIMONIALS

"The Pointer Plus is great for my bad ankles. I can already feel the improvements after just a couple weeks, thanks!"
- Ervin Burress, Tacoma, WA

"This trigger point locator is extremely safe and simple to use for home treatment. I would suggest it as an effective alternative or addition to regular acupuncture therapy."
- Dr. Thomas Chen, Shanghai, China

Output Intensity	0 to 22 mA
Frequency of Output	10 Hz.
Output Intensity Control	OFF, 0 to 10
Pulse Width	240 usec
Pulse Shape	Biphasic square pulse with negative spike
Push Type Button	ON/STI, OFF/APD
Indicator Lamp	Pulse Rate Indicator
Power Supply	9 volt battery
Pulse Modes	Continuous
Point Detection	Sound and Light Indicators
Color	Beige
Size	170 x 33x 33 mm
Operation Temp	+16.°C TO +30.°C
Output Channels	One

Cleaning: DO NOT IMMERSE THE POINTER PLUS STIMULATOR / LOCATOR IN ANY CLEANING SOLUTION.
The Pointer PLus stimulator / Locator should be periodically wiped clean using a damp cloth and a solution of mild sop and water. Use of other cleaning solutions may damage the case. The metal electrodes should be thoroughly washed in a 50% mixture of isopropyl alcohol and water. The wire should be wiped clean with a cloth dampened with a mild soap solution and then wiped dry.

[<<Prev] 1 2 3

Current no reviews for this product

Write a new review >>